Whistler LASER/RADAR DETECTOR Owner's Manual download pdf (Page 3)

Mounting Guidelines

• Mount the unit as low as possible near the

center of the windshield.

• Do not mount the unit behind wipers,

ornaments, mirrored sunscreens, etc. These

obstructions have metal surfaces which can

affect radar and laser signals and reduce

critical warning time. (Regular tinted glass

does not affect reception).

• Some windshields have an Instaclear

™

Electriclear

™

type coating, which affect radar

signals. Consult your dealer or the owner’s

manual supplied with your vehicle to determine

if your windshield has this coating.

• Avoid placing the unit in direct contact with the

windshield.

• To reduce the possibility of theft, conceal your

unit when not in use.

: Make sure the unit is level

INSTALLATION

Windshield Mounting

• Install the two suction cups and rubber bumper

onto the bracket by fitting them into their holes.

• Press the suction cups onto the windshield at the

location you have chosen.

Important: Some newer cars have a plastic safety

coating on the inside of the windshield. The wind-

shield bracket may leave permanent marks on this

type of surface. To find out if your vehicle has this

type of windshield, check the owner’s manual or ask

your dealer. We recommend that you do not leave

the suction cup bracket on the window in direct sun-

light. If the detector is removed, this may cause

blistering of the dash in some vehicles.

• Slide the detector onto the bracket until it locks into

place.

• If necessary, the unit may be leveled by bending the

windshield bracket. Press the bracket release button

and remove the detector before bending.

Power Cord Connection

• Plug the small end of the power cord into the

unit’s power jack.

• Plug the large end into the vehicle’s cigarette lighter.

Cord fits tightly into detector. When

installing the cord, expect some resistance.

Fuse Replacement

The lighter socket plug is equipped with a

replaceable 2 amp 3AG fuse located behind the

silver tip. To replace the fuse, carefully unscrew

the tip of the plug.

Unscrew slowly. The tip contains a

spring which may fly out when disassembling.

Insert the new fuse with the spring and screw on

the tip. With use, screw cap on plug may loosen.

Retighten occasionally.

INSTALLATION CONT.

Windshield

Mounting

Rubber Bumper

OPERATION

Power On, Self Test

To turn the Power ON or OFF, push the center

of the Power/Volume button.

Each time your Whistler detector is turned on,

an automatic self-test sequence confirms that

the speaker and visual displays are functional.

• Display shows in order:

1. WHISTLER 2. X-band 3. K-band 4. Ka-band

5. LASER 6

SR OFF 7. VOICE ON 8. POP ON

9. B SVR ON 10. FILTER 11. HIGHWAY

Teach/Tutorial Mode

Provides simulated alerts for each type of signal.

• Press City and Quiet buttons simultaneously

• Display Shows:

• Press Dark button to exit.

Setting Saver

Setting Saver saves your personalized settings

so that when the detector is turned off and then

on again, you do not have to re-enter them.

Feature Engaged Confirmation

Each time a button is pressed, one beep confirms

feature “on”, two beeps confirm feature “off”.

Integrated Real Voice

When selected, Real Voice

will be used to articu-

late the following:

Band Identification

2. Safety W

ning System messages

3. Feature Selection

Note: In certain cases the voice message does not

replicate the text message.

1 2 3 4 5 6 7 8 9

Comments to this Manuals

No comments

Whistler LASER/RADAR DETECTOR Owner's Manual Page 3

Comments to this Manuals

Related products and manuals for Radar detectors Whistler LASER/RADAR DETECTOR