Whistler PI-3000 Owner's Manual download pdf (Page 15)

TROUBLESHOOTING

PROBLEM: TV Interference

Problem Solution

Electrical interference from Add a Ferrite data line fil-

ter inverter. on to the TV power cord.

This filter is available at

RadioShack, or other

electronic supply stores.

part number 273-105.

PROBLEM: Low or No Output Voltage

Problem Solution

Using incorrect type of Use true RMS reading meter

voltmeter to test output See

"For You Technical

voltage. Types"

Section of this manual.

PROBLEM: Low Battery Alarm On All The Time

Problem Solution

Input voltage below Keep input voltage above

11 volts. 11 volts to maintain

regulation.

Poor or weak battery Replace battery.

condition.

Inadequate power being Use lower gauge wire. See

delivered to the inverter “Wire Cable Gauges”

or excessive voltage drop. section of this manual.

Keep wire length as short

as possible.

OPERATION SUMMARY

• Avoid placing the inverter near sources of heat or in

direct sunlight.

• When in use, make certain that the inverter is properly

ventilated.

• Do not use the inverter near flammable materials,

fumes, or gases.

• Always operate the inverter in accordance with the

instructions in this manual. Failure to do so may result

in property damage, personal injury, or loss of life.

• While connecting the inverter to the power source,

make certain that the inverter is well removed from

any potential source of flammable fumes or gases.

• Always ground the inverter before operating it.

• In the event a continuous audible alarm or automatic

shut off, turn the inverter OFF immediately. Do not

restart the inverter until the source of the problem has

been identified and corrected.

1 2 ... 10 11 12 13 14 15 16 17 18

Comments to this Manuals

No comments

Whistler PI-3000 Owner's Manual Page 15

Comments to this Manuals

Related products and manuals for Power adapters & inverters Whistler PI-3000