Whistler PI-3000 Owner's Manual download pdf (Page 9)

Adapter." Use of #0 gauge wire to make the connections to

the inverter may require a "0 to 4 Gauge Adapter." Both

adapters are available through electronic supply stores

including Radio Shack. Radio Shack part number is listed below:

O Ring Adapter: RSU11538139

0 to 4 Gauge Adapter: RSU11538667

2000 and 3000

When the inverter and the battery are set up within four

feet

of each other, use a minimum of #2 gauge wire to make the

connections. Within four to six feet, use two #0 gauge wire.

At distances of more than six feet, use #0 gauge wires

connected in parallel to the battery.

CABLE INFORMATION

OPERATION

Making the Connection.

1. Make certain that the Power switch is in the OFF (O) position.

2. Connect the cables to the power input terminals at the

rear of the inverter and tighten the screws to make a

secure connection.

Do not use tools to tighten these screws.

(To make these connections on the 2000 and 3000,

remove the supplied nut at each terminal on the inverter,

install the wire connectors flush with the metal backing

plates and refasten the nuts securely.

3. Connect the cable from the Negative (-) terminal on

the inverter to the Negative (-) terminal on the 12 volt

power source. Make certain the connection is secure.

4. Confirm that the cable you have just installed is

properly connected. Specifically, make certain that

the cable is connected to the Negative (-) terminals

on both the inverter and the 12 volt power source.

5. Connect the cable from the Positive (+) terminal on

the inverter to the Positive (+) terminal on the power

source.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

No comments

Whistler PI-3000 Owner's Manual Page 9